Vacuum table 180/120

The BELO low pressure table 180/120 was specifically designed for use in textile preservation.

This workplace is available without a negative pressure generator and pre‑separator.

The BELO suction table 180/120 comes with two worktop versions:
– a stainless‑steel perforated sheet (standard version)
– a fully perforated sandwich construction.


Using the sandwich construction, it is possible to expand the system to a partial vacuum table. This special design allows for partial treatment of the object using standard methods without having to partially cover or move the object on the surface.

This allows for targeted, separate treatment of individual areas of an object. The negative pressure is applied locally. The extraction is limited to the specific area within the partial negative pressure funnel beneath the worktop.

By removing the substructure and the tabletop, the vacuum table can also be used as a washbasin with a maximum flooding depth of approximately 40 mm. A drain with a ball valve is located on the underside of the basin in the corner area. The accompanying base frame is made of aluminum profile with lockable casters.

Different work surfaces allow for individual adaptation of the work area to the respective requirements. This makes it possible to vary the work area individually depending on the needs of the object.